

SpeedoGDOS Font Pack Installation Instructions
----------------------------------------------



Installation for SpeedoGDOS users,

1. All Files in the folder "SPD_TDF" are to be copied into the 
folder "SPDFONTS" on your hard disk. In most cases this is located 
on the boot drive. In the event your SpeedoGDOS files are located 
in another folder, then copy the files into the corresponding 
folder.

**Note: Files should NOT to copied into a sub-directory within 
this folder**

2. Start the Outline accessory.

3. Select the menu entry "Install All".

4. Confirm by clicking on "OK".

5. After fonts are visible in the file selection box select the 
menu entry "Save".

6. Confirm by clicking on "OK".

7. When finished select the menu entry "Exit".

!! That's it !!




Installation for That's Write 3 users

1. On disk 1 you will find a file named INFO.TXT listing all the 
fonts on the disks. Use this file to locate the SPEEDO fonts you 
want to install.

2. Copy the SPEEDO fonts (extension .SPD) from the "SPD_TF" folder 
to your BTFONTS folder. (Normally inside your TWRITE3 folder).

3. Copy the corresponding .PF file from the folder "PF" folder to 
your TWRITE3 folder.

4. Run That's Write 3 and click on Load Font. Click on "Family" - 
not an obvious place to click! You should get a dialogue asking if 
you want to update the font list... select "Yes".

!! That's It !!